dana 60

[tonkatoy]

i need a chevy dana 60 frontend reasonable $$$$$$$$$$$ or trade dana 60 ford frontend for chevy

[chevy4x4boy]

I have a dually chevy 60 if interested

[tonkatoy]

is it a front end and whats the differance between a regular 60 front end and a dually front end

[MrClemons]

is it a front end and whats the differance between a regular 60 front end and a dually front end

i can tell you that it is a front end with out even asking and the difference is the dually front is wider then the srw front

[chevy4x4boy]

the difference is the hubs on a chevy

[tonkatoy]

so is this good or bad and whats the differance if i was going to put it in the mud truck

[chevy4x4boy]

theres no difference

[tonkatoy]

sent u a pm

[MrClemons]

theres no difference

yes there is, the hubs are different making it be a few inches wider wms to wms

[tonkatoy]

so can u put reg hubs on this or would u need to ? and dose a standard rim fit on this, anyone

[MrClemons]

i belive you can put standard hubs on but i have not done it my self so i cant say forsure....
yes normal wheels will fit But if you dont change the back spacing on them they will have a wider stance then the rear.

[WRECK$HIT]

The dually front ends are not as strong as the normal front ends

[tie6044]

What's weaker on them?? I always thought they would be great for a mud truck because it puts you in a different rut than everyone else.
I can get you a dually set (Dana 60 front and 70 rear) if you haven't found one yet.

[WRECK$HIT]

I was always told the shafts were smaller, but i could easily be wrong.

[tie6044]

Nope, same shafts and u-joint.

[GrayGuy]

You can also run Hummer bead locks on the duelie axles and because of their odd back spacing, it ends up being about the same track width. Or you can buy my d60's in the forsale section.

[ol'e blue]

I run the duely dana 60 front i had a buddy chuck it up in his lathe and turn the outer part down cause the center of a duely rim is about 3/4 to a 1/2 in bigger dia. and then with the rotors off he trimmed the front of the back flanges to accomidate newer style rotors with studs instead of being bolted on

[Diggerz]

hey tonka how much for the ford dana 60?