Axels

[Bli1822001]

Would it be bad to run a dana 60 in the front and a dana 44 in the rear???

[bogger333333]

You could do this but it would be better to have a Dana 60,70 rear or a 14 bolt

[Bli1822001]

the only reason i'm asking is the truck im thinkin' about buying has a 44 in the rear and independent in the front. Then I'd just put a 60 in the front for future improvments to the rear. Due to tight budget I figured it would be smarter to buy 1 azel in the future instead of 2. If that makes any sense. I just didn't know if I'd run into any problems

[toofast4you_yamaha]

hey there was 2 14 bolt rear ends on craigslist for 250 bucks . on was a welded locker and one was nt

[toofast4you_yamaha]

and from what i know a 60 in the front and a 14 in the rear is a really good combo unless u have 60's all the way around prolly a better one though

[bogger333333]

Yea 60 front and rear is good but 14 bolt is a lot stronger. But it doesn't have good clearance and it is very heavy. As of running 60 front and 44 back you would have different bolt patterns.

[redchevy383]

look around fourteen bolts are every were probly get a whole truck for two fifty

[WRECK$HIT]

if your looking at buying a dana 60 front you might as well spend a extra 100 or 2 and buy 2.5 tons. i know of some 2.5 gmcs for a good price cheaper than a 60

[Bli1822001]

Well guys I think i just found a set of rockwells for 700 bucks. I might just have to go with that

[MrClemons]

Well guys I think i just found a set of rockwells for 700 bucks. I might just have to go with that

if you dont buy them, i will, and hell ill even give you a little bit of cash for finding the deal!