View Full Version : Distributors
04-05-2006, 08:32 PM
hey guys. its my first time to take Distributors out and put it back in... what do i need to do to do that?? cuz if i took it out. put back in wrong way it will screw up the spark right? tell me how to do it right way...
04-06-2006, 12:24 AM
It not hard as long as when you take the cap off get the rotor pointing to the #1 cylinder buy turning over the motor. Now remove the hold down and pull it up. Once the dist is out DONT TURN MOTOR OVER or you have to go thru and find TDC now when u install new dist point the rotor just back a few degrees from where you want the rotor to point and slide it in it will move forward when it slides into gear. Make sure you get it all the way down. This may take a few tries. I also would suggest taking a marker and marking on your intake excatly where it is pointing. This is what works for me other people may better ways.
04-06-2006, 01:07 PM
yeah that what i thought so.. thanks buddy!
05-19-2006, 08:30 PM
hey there. a question.. if i have distributors installed in wrong gear, the motor wont start right??
Powered by vBulletin™ Version 4.0.5 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.